CerMark LMM-6000 Aerosol$77.35 USD
- $77.35 USD|
- $449.10 USD|$464.10 USD
- $850.85 USD|$928.20 USD
LMM-6000 is a flexible metal marking product recommended for standard metals. The following
provides a list of substrates on which LMM-6000 works well. This list is not exhaustive, however, so if
your substrate does not appear on this list, please call or email LJS for suggestions and
recommendations for your laser application.
- Stainless Steel
- Stainless Steel - Bright Annealed
- Galvanized Steel
- Carbon Steel
- Nickel Plating
- All LMM-6000 products (aerosol and ink) are considered by the US Department of Transportation (DOT) to be “ORM-D” or “Consumer Commodity”. These products may be shipped via ground or air.Ground shipping is the default shipping method for this product. Note, LMM-6000 aerosol/Paste is subject to an additional $40 hazardous materials packing fee if shipped via air. This is due to regulations around the shipping of pressurized cans on airplanes.
- Overnight Shipping of LMM-6000 aerosol may be available with the hazardous material packaging listed above; however, LMM-14 Paste can be shipped via Overnight service without a hazardous charge!
- LJS Ships all Metal Marking Compound (LMM-6000 and LMM-14) via FedEx Ground unless otherwise indicated.
FedEx Ground Transit Times from Laser Jump Start to U.S. Business Destinations
Note: Home Delivery shipping is slightly higher and may take an extra day for delivery for reference.
All LMM-6000 products should be stored between 40ºF (5ºC) and 95ºF (35ºC) in a dark, dry place. Aerosol cans should be stored on their side rather than their bottom, as the LMM-6000 material can settle and clump together inside the can. Side storage allows for even dispersion upon shaking.
LMM-6000 is an alcohol-based material. After laser bonding, any excess, un-bonded material can be washed off the substrate and down the drain into your normal water/sewer waste area. Note: Using hot water and rubbing the substrate surface with rubber or latex gloves works the best with regard to cleaning parts/materials after laser processing.
Unused aerosol cans that are still pressurized should be de-pressurized in a well-ventilated area (the propellants should be completely expelled from the can) and disposed of in your regular trash and solid waste area.